XIOLIFT Switching Power Supply Board N-power-a

XIOLIFT Switching Power Supply Board N-power-a is used in elevator power supply circuit and control system electrical maintenance applications.

This board may be installed inside the elevator control cabinet, power supply section, or related electrical unit, depending on the original XIOLIFT elevator configuration. It should be confirmed by the old PCB marking, board label, connector layout, terminal position, wiring direction, and installation location before ordering.

In elevator spare parts purchasing, this product may be searched as:

• XIOLIFT Switching Power Supply Board

• XIOLIFT N-power-a Board

• N-power-a Power Board

• Elevator Power Supply PCB

• Elevator Power Board

• XIOLIFT Elevator PCB Board

The main references for this page are:

• N-power-a

• N Power A

• N-power

• XIOLIFT N-power-a

• XIOLIFT Switching Power Supply Board N-power-a

Before ordering, buyers should confirm:

• complete PCB marking on the old board

• whether the board shows N-power-a

• connector quantity and position

• terminal layout and wiring direction

• input and output marking if shown

• board version or revision if available

• installation position in the cabinet or power unit

• old board front and back photos

• connector close-up photos

• fault symptom from the elevator site

This board may be checked when the elevator has power supply abnormality, board power loss, unstable low-voltage circuit, damaged connector, burned component, or control cabinet electrical fault. These problems may also come from wiring, load-side short circuit, power module failure, loose terminals, or other control boards.

For buyers in Saudi Arabia, Jordan, Egypt, Iraq, UAE, Brazil, Chile, Spain, and Italy, clear old-board photos and connector photos are recommended before shipment, especially when ordering this board together with other XIOLIFT elevator spare parts.